Register application administration enabled scoped application

  • Versão de lançamento: Australia
  • Atualizado 12 de mar. de 2026
  • 1 min. de leitura

    • If your application is an application admin enabled scoped application, register the application with Universal Request (UR) to make your application’s service and service set data available for the Universal Request application to work.

    Antes de Iniciar

    Role required: admin

    Por Que e Quando Desempenhar Esta Tarefa

    After you configure your service, you must perform these steps and create the following ACL-inheritance entries. This enables Universal Request to use your application’s service and service set data.

    Only UR administrator [sn_uni_req.ur_admin] can assign scoped UR roles.

    To configure your system, you must log in as a System Administrator [admin]. The UR Administrator [sn_uni_req.ur_admin] role is contained in the System Administrator [admin] role. The combination of these two roles allows a user to perform all tasks associated with configuring your system.

    After system configuration, ensure that only the UR Administrator [sn_uni_req.ur_admin] role has access to sensitive information. Remove the UR Administrator role from System Administrator [admin] role to prevent the System Administrator from viewing sensitive UR information. For more information, see Remove UR administrator role from system administrator.

    After granting access, define the sn_uni_req.min_admin_count property in the system properties for UR to ensure that a minimum number of scoped administrators exist and the application is not locked out in one administrators absence.

    Procedimento

    1. In the navigation panel, enter sys_scoped_admin_acl_inheritance.list.
    2. In the Application Administration ACL Inheritance page, click New.
    3. Select Service Set from the Table drop-down list.
    4. Check that the Application is your scoped application
    5. Click Submit.
      Creates an ACL inheritance record for the service set table in your scoped application.
    6. In the Application Administration ACL Inheritance page, click New again.
    7. Select Service Configuration from the Table drop-down list.
    8. Check that the Application is your scoped application
    9. Click Submit.
      Creates an ACL inheritance record for the service configuration table in your scoped application.