Use the Trim component

  • Freigeben Version: Australia
  • Aktualisiert 12. März 2026
  • 1 Minute Lesedauer

    • Remove the transparent pixels from the borders of an image as part of an automation Workflow by using the Trim component in RPA Desktop Design Studio.

    Vorbereitungen

    Role required: none

    Warum und wann dieser Vorgang ausgeführt wird

    You can configure the properties for the Trim component. For more information about these properties, see Properties of the Image Utilities components.

    Prozedur

    1. In the Toolbox pane, navigate to Utilities > Image Utilities.
    2. Drag the Trim component to the Design surface.
    3. To configure the input field, see Configure port properties.
    4. Connect the data and control ports of the Trim component to the corresponding ports of the other components as described in the following table.
      Port type Purpose of connection Mandatory?
      Data In (Image) Takes the image that the method trims from a previously executed component. Yes
      Data Out (Return) Returns the trimmed image and passes to the next component. Yes.

      To preview the data, right-click the Return field and click Preview Data.
      Control In Connects to the Control Out port of one or more components. Yes
      Control Out Connects to the Control In port of any other component. No. Connecting the port is optional.
    5. Wahlweise: To test the component, under the DESIGN tab, click Run.