Use the MoveDirectory component

  • Versão de lançamento: Australia
  • Atualizado 12 de mar. de 2026
  • 1 min. de leitura

    • Move a directory and its contents to a new location by using the MoveDirectory component in RPA Desktop Design Studio.

    Antes de Iniciar

    Role required: none

    Por Que e Quando Desempenhar Esta Tarefa

    You can configure the properties for the MoveDirectory component. For more information about these properties, see Properties of the Directory components.

    Procedimento

    1. In the Toolbox pane, navigate to Utilities > Directory.
    2. Drag the MoveDirectory component to the Design surface.
    3. To configure the input fields, see Configure port properties.
    4. Connect the data and control ports of the MoveDirectory component to the corresponding ports of the other components as described in the following table.
      Port type Purpose of connection Mandatory?
      Data In (sourceDirPath) Takes the path to the source directory from a previously executed component. Yes
      Data IN (destDirPath) Takes the path to the destination directory from a previously executed component. Yes
      Data In (overwrite) Takes the Boolean response on whether the method should overwrite the same directory in the destination folder from a previously executed component. No
      Control In Connects to the Control Out port of one or more components. Yes
      Control Out Connects to the Control In port of another component or the default end component. No. Connecting the port is optional.
    5. Opcional: To test the component, under the DESIGN tab, click Run.