Run your test assignments in Test Management 2.0

  • Freigeben Version: Australia
  • Aktualisiert 12. März 2026
  • 1 Minute Lesedauer

    • Run your test assignments and capture the results.

    Vorbereitungen

    Role required: sn_test_management.tester

    Prozedur

    1. Navigate to All > Test Management 2.0 > Tests Assigned to me.
    2. Select the required tests and click Run.
      Hinweis:
      Only the tests that are in the Ready state can be run.
    3. In the pop-up, select the execution environment on which the tests must be run.
    4. In the Test Execution pop-up, mark a step as passed, failed, or blocked using the following icons.
      IconDescription
      Icon to indicate a step as passed Passed.
      Icon to indicate a step as failed Failed. In this state options to add comments and attachments are available.
      Icon to indicate a step as blocked Blocked. In this state options to add comments and attachments are available.
      To pause and work on the test at a later point in time, click Pause.
    5. Click Done.

    Ergebnisse

    Test results are saved to the Test Result form. The overall status of the test is defined by statuses of the test steps:
    • If all the test steps are passed, the status of the test is Passed.
    • If at least one step of the test is not run, the status of the test is Not finished.
    • If at least one step of the test fails, the overall status of the test is Failed.This rule takes precedence over the previous rule.
    • If at least one step of the test is blocked, the overall status of the test is Blocked. This rule takes precedence over the previous two rules.

    Nächste Maßnahme

    View all the test results in the Test Management 2.0 > Test Runs.